How long automotive seal needs to be replaced

We produce Side Window Strip,if you need our products,you can contact us.
Replacing the time required depends on the circumstances, first check whether the large crack seal, with or without fracture. If the seals are broken, it can be repaired using an adhesive. Particularly the use of special adhesive seal, it is easy to crack the big strip mended. Of course, if the seal of serious injury, or a greater degree of aging, it is best to replace the new seal easy.

Side Window Strip

1, the owner of the car after using detergent for cleaning windows and doors sealed plastic strips, preferably coated with a layer of high permeability protective agent, so that both can prevent aging seal greatly improve the seal tightness. In addition, it is easy to fill up the gap between the seal dust, causing corrosion. For this reason, you should use a brush to remove dust and other clean.

2, in replacement of the entire body, should be coated in a layer of sealant overlapping portions of the weld, the layer thickness should be about 1mm, and may not have virtual sticky glue, bubbles and other defects. In the entire floor surface and a lower surface of the front cover should be coated with elastomeric coating and anti-corrosion coating of 3mm-4mm. These measures not only can greatly enhance the vehicle body sealing and slow down the corrosion rate, but also can greatly improve the ride comfort.

3, the door and the body of a seal is more difficult, the sealing requirements more stringent, should be sealed part of a long, cross-sectional shape of each of the different parts of the seal, and the doors open and close frequently. On limousine often set up three, four seals, install front pillar and roof side beam portion quadruple seal construction. This multi-channel sealing crevices are generally arranged in the front door, in addition to having a sealing function, as well as automotive noise reduction effect.

4, in the rear window glass is damaged, the owners replaced with glass, to check the seal for damage. Because the windows after the repair is often not reply to the original shape, therefore, when in addition to ensure easy pulling or lifting window glass, but also pay attention to the sealing around the window glass. If the glass with glass slot gap uneven, rubber and glass tank is bad, the owner can hand can easily pull off the seal.

5, the owner at the time of changing the roof, should be coated with a layer of conductive sealant on the roof at the periphery of the nip, to be welded after a good bath in water and applied over the seams hemming tape, which not only helps the body seal, but also prevent the body due to flange welds early stagnant water to produce rust.

6, car sunroof is the basic configuration for most family car. When the car sunroof open, rubber seal track exposed to air, it is inevitable dust accumulation, even ran a small gravel. Prolonged use may lead to deformation due to wear and skylights, and plug the drain hole. Therefore, regular cleaning of the track, the track is very important to apply lubricant. Although automotive sealing strip small parts inside the body, but it can ensure steady heavy door switch, so that the car can avoid the storm, dust, insulation, sound insulation, windows and doors on the edge of the transfer for decorative effect. When the body is subjected to vibration and distortion, seals also play a buffer, shock-absorbing, protective effect of the glass.